# Source: legacy.adoc

*Note: This file could not be automatically converted from AsciiDoc.*

== Legacy Support

WARNING: These instructions are for the original Raspberry Pi, Model A, and B, boards only. To identify an original Raspberry Pi, check the GPIO header connector. Only the original model has a 26-pin GPIO header connector; subsequent models have 40 pins.

The DSI connector on both the Raspberry Pi 1 Model A and B boards does not have the I2C connections required to talk to the touchscreen controller and DSI controller. To work around this, use the additional set of jumper cables provided with the display kit. Connect SCL/SDA on the GPIO header to the horizontal pins marked SCL/SDA on the display board. Power the Model A/B via the GPIO pins using the jumper cables.

DSI display autodetection is disabled by default on these boards. To enable detection, add the following line to the xref:../computers/config_txt.adoc#what-is-config-txt[`/boot/firmware/config.txt`] file:

[source,ini]
----
ignore_lcd=0
----

Power the setup via the `PWR IN` micro-USB connector on the display board. Do not power the setup via the Raspberry Pi's micro-USB port. This will exceed the input polyfuse's maximum current rating, since the display consumes approximately 400mA.