# Source: https://docs.datadoghq.com/agent/configuration/proxy_squid.md

---
title: Using a Squid proxy
description: >-
  Set up Squid as a forward proxy to route Datadog Agent traffic through an
  HTTP/HTTPS proxy server when direct internet access is limited.
breadcrumbs: Docs > Agent > Agent Configuration > Using a Squid proxy
---

# Using a Squid proxy

[Squid](http://www.squid-cache.org/) is a forward proxy for the web supporting HTTP, HTTPS, FTP, and more. It runs on most available operating systems, including Windows, and is licensed under the GNU GPL license. Squid is a straightforward option if you do not already have a running web proxy in your network. **If you already have an existing proxy server, you do not need to use Squid.** Instead, follow the instructions in [Agent Proxy Configuration](https://docs.datadoghq.com/agent/configuration/proxy/).

## Proxy forwarding with Squid{% #proxy-forwarding-with-squid %}

To configure Squid to send traffic to Datadog, follow the instructions below to configure Squid, start the squid service, and then configure and restart the Datadog Agent.

### Configure Squid to only send traffic to Datadog{% #configure-squid-to-only-send-traffic-to-datadog %}

Install Squid on a host that has connectivity to both your internal Agents and Datadog. Use your operating system's package manager, or install the software directly from [Squid's project page](http://www.squid-cache.org/).

To configure Squid, edit the configuration file. This file is usually located at `/etc/squid/squid.conf` on Linux or `C:\squid\etc\squid.conf` in Windows. For other operating systems, see [Agent configuration directory](https://docs.datadoghq.com/agent/configuration/agent-configuration-files#agent-configuration-directory).

Edit your `squid.conf` configuration file so that Squid is able to accept local traffic and forward it to the necessary Datadog intakes:

```
http_port 0.0.0.0:3128

acl local src 127.0.0.1/32

acl Datadog dstdomain .

http_access allow Datadog
http_access allow local manager
```

### Start Squid{% #start-squid %}

Start (or restart) Squid so that your new configurations can be applied.

{% tab title="Linux" %}

```bash
sudo systemctl start squid
```

If Squid is already running, restart Squid instead with the following command:

```bash
sudo systemctl restart squid
```

{% /tab %}

{% tab title="Windows" %}
If you are configuring Squid on Windows, you must first [configure Squid as a system service][4]. You can then run the following in an Administrator command prompt:

```bash
net start squid
```

If Squid is already running, restart Squid instead with the following commands:

```bash
net stop squid
net start squid
```

{% /tab %}

### Configure the Datadog Agent{% #configure-the-datadog-agent %}

Modify the Agent's configuration file (`datadog.yaml`) to include the following:

```yaml
proxy:
  http: http://127.0.0.1:3128
  https: http://127.0.0.1:3128
```

After saving these changes, [restart the Agent](https://docs.datadoghq.com/agent/configuration/agent-commands/).

Verify that Datadog is able to receive the data from your Agent(s) by checking your [Infrastructure Overview](https://app.datadoghq.com/infrastructure).

## Further Reading{% #further-reading %}

- [Agent Proxy Configuration](https://docs.datadoghq.com/agent/configuration/proxy/)